Bolting the Countertop with NCR Millwork

The kiosk must be bolted to the countertop. The countertop construction determines the type of anchors to use—bolts and nuts, lag bolts, screws, and so forth.

1.Mark the location of the anchor holes of the kiosk on the countertop or use the dimensions below.

2.Drill the four holes on the countertop as needed for the anchors being used.

Note:  The anchors are not shipped with the kiosk and must be obtained locally.

3.Mount and partially tighten the two front anchors. Make sure to leave room for the kiosk bucket to slide under the screw heads or lock-washers.

4.Place the kiosk on the countertop with the anchors as its locating feature.

5.Slide the kiosk to the right.

6.Mount the two anchors. Tighten all mounting anchors.